Impulse 2801 User Manual download pdf (Page 5)

Installation

Sealevel Systems SeaLINK+8 Page 2

Installation

Operating System Installation

Choose Install Software at the beginning of the CD and install SeaCOM.

System Installation

The screen captures below are taken from a Windows 98 installation. Your

particular operating system may differ slightly from what is shown based on

your version of Windows.

The SeaLINK+8 can be connected to any upstream type “A” port, either at the

PC host or an upstream hub. The SeaLINK+8 is hot pluggable, meaning there is

no need to power down your computer prior to installation.

Connect the SeaLINK+8 to an upstream host or hub.

The New Hardware Found wizard will now proceed to locate the appropriate

drivers. These drivers were installed during the SeaCOM software setup

procedure. Once the drivers are found a new window will pop up indicating the

installation of each of the eight new ports.

If you view the system’s Device Manager, you should have new “COM” ports

in the Ports (COM & LPT) Device Class. This is shown on the following page.

1 2 3 4 5 6 7 8 9 10 ... 17 18

No comments

Impulse 2801 User Manual Page 5